Woods-powr-grip LB10VLB Manuel d'utilisateur télécharger pdf (Page 5)

Rev 0.1/12-12 3 LB10LVB: #35206AFT

OPERATION

Operate the vacuum lifter as directed in the OPERATION section of the MRTALP lifter's instruction

manual, with the following exceptions:

WARNING: Never attempt to lift load when lifter is in horizontal

orientation.

In order to use the Vertical Lift Bar, the lifter must be attached only to loads

oriented in the upright position. Center the pad frame from left to right on the

load, and position the uppermost vacuum pad near the top edge. This position will maximize

stability while lifting the load. Make sure that all vacuum pads will fit entirely on the load’s

contact surface (see SPECIFICATIONS: Pad Spread in MRTALP lifter's instruction manual) and

that they will be loaded evenly while lifting. Then apply the lifter to the load so that the pads are

touching the contact surface.

MAINTENANCE

When performing inspections and tests of the lifter as directed in the MAINTENANCE section of

the MRTALP lifter's instruction manual, be sure to include all relevant parts of the Vertical Lift Bar

whenever applicable.

REPLACEMENT PARTS LIST

Stock No.

Description

Qty.

49122

End Plug - 2" x 2" x 1/4" [50.8 mm x 50.8 mm x 6.4 mm] Tubing Size

12822

3/8" Flat Washer

12756

3/8" Lock Washer

11120

3/8-16 Hex Nut

10916

Shoulder Bolt - Socket Head - 1/2" x 2 1/2" x 3/8-16 Thread

08093

3/4" Rubber Bumper

SERVICE ONLY WITH IDENTICAL REPLACEMENT PARTS

SUPPLIED BY OR APPROVED BY WOOD'S POWR-GRIP CO., INC.

1 2 3 4 5 6

Pas de commentaire

Woods-powr-grip LB10VLB Manuel d'utilisateur Page 5