Woods-powr-grip PFHL89DC Manuel d'utilisateur télécharger pdf (Page 23)

Rev 26.0/12-13 21 PF-DC: #35131

• Contaminates on the pad face or sealing edges: Soil build-up can prevent pads from sealing

adequately or reduce the friction coefficient (see discussion preceding). Follow the directions

to clean pads as necessary (see discussion to follow).

• Filter screen missing from pad face: This screen helps prevent debris from plugging the

vacuum hose and the air filter. Replace any missing screen immediately (see REPLACEMENT

PARTS LIST).

• Nicks, cuts or abrasions in sealing edges: Pad damage can reduce the lifting capacity of the

lifter. Replace any damaged pad immediately (see REPLACEMENT PARTS LIST).

WARNING: Replace vacuum pad if sealing edge has any nicks, cuts or

abrasions.

• Wear, stiffness or glaze: See Friction Coefficient preceding. Replace any pad that exhibits

wear, stiffness or glaze (see REPLACEMENT PARTS LIST).

Cleaning

Regularly clean the face of each vacuum pad to remove oil, dust and any other contaminates.

Acceptable cleaning agents include soapy water and other mild cleansers. Do

not

use solvents,

petroleum-based products (including kerosene, gasoline and diesel fuel) or any harsh chemicals

for cleaning. Do

not

use unauthorized rubber cleaners or conditioners, such as those intended

for cleaning tires or vinyl surfaces, because those products can leave a hazardous film on vacuum

pads which significantly reduces their lifting capacity (see Friction Coefficient preceding). The

use of any unauthorized cleaning agent is prohibited because it could damage the pad and/or

create a hazard to the operator or others.

WARNING: Never use solvents, gasoline or other harsh chemicals to clean

vacuum pad.

WARNING: Never use unauthorized rubber cleaners or conditioners to clean

vacuum pad.

To prevent liquid from contaminating the vacuum system during cleaning, cover the suction hole

in the recess for the filter screen or make sure the pad faces downward. Use a clean sponge or

lint-free cloth to apply an authorized cleanser and wipe the pad face clean. A toothbrush (or

similar brush with bristles

that do not harm rubber

) may be used to remove contaminates

clinging to sealing edges.

Wipe all residue from the pad face, and allow the pad to dry

completely before using the lifter.

If these cleaning methods are not successful, contact Wood’s Powr-Grip or an authorized dealer for assistance.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Pas de commentaire

Woods-powr-grip PFHL89DC Manuel d'utilisateur Page 23